ZTree.com  | ZEN  | About...  

 Index   Back

reset when leaving Treespec command   [Discuss]

By: Art Kocsis     So Calif  
Date: Jul 24,2016 at 06:59
In Response to: reset when leaving Treespec command (Hartmut Schneider)

> There is no config option. But see below
Ah. Thanks for the clarification.

> > Is what you are asking for that the option resets when you exit Treespec
> > so that the next time you open it it always starts with edit=No?
> Yes, this is my ZEP.
> Makes the Edit state predictable even in Macro.

> We still have to agree above the initial state.
> I'd suggest Edit=No, as it is when the ZTree session is started.

It only makes sense for the reset state to be identical to the initial state when ZTree loads which would be Edit=No. Otherwise confusion and conflict will ensue.

However, I really fail to see any reason to have an Edit=No state in the first place. Whenever I use treespec I either want the history value as is and just press enter or I want to edit it. I don't need a ban on editing to just accept the history value without editing and I find it annoying to have to go the extra F5 step when I do want to edit it. What am I missing?


Namaste', Art

Press any key to exit,
Press any other key to continue...
- unknown

578 views      
Thread locked
 

Messages in this Thread

 
94,426 Postings in 11,918 Threads, 348 registered users, 6 users online (0 registered, 6 guests)
Index | Admin contact |   Forum Time: Sep 22, 2019 - 12:56 pm EDT  |  Hits:28,656,347  (1,189 Today )
RSS Feed